F
When you are done, press the [Esc] button to exit the
correction menu.
Because the correction method was changed to Quick Corner from
Keystone in the configuration menu, when [w/], [v/], [</ ]
and [>/] buttons are pressed later, the screen for selecting the
corner in procedure 2 is displayed. Change Keystone from the
configuration menu to H/V-Keystone if you want to correct H/V-
Keystone when pressing the [w/], [v/], [</] and [
>/ ]
buttons on the control panel. s p.55
q
If the [Esc] button is held down for about two seconds while
correcting with Quick Corner, the following screen is displayed.
Reset Quick Corner: Resets the result of Quick Corner corrections.
Switch to H/V-Keystone: Switches the correction method to H/V-
Keystone. s "H/V-Keystone" p.23

H/V-Keystone

Procedure
Press the [w/], [v/], [</] and [>/] buttons on the control
panel to adjust keystone settings in the horizontal and vertical
directions independently.
q
This adjustment can also be made from H/V-Keystone on the Settings
menu. s p.55
•Correcting vertical keystone
Vertical keystone can be corrected to a vertical projector tilt of up to 30˚
against the screen. If you use the projector tilted at an angle of more than
30˚, it could be damaged and cause an accident.
If the [w/] and [v/] buttons are pressed simultaneously for at least
1 second, the value of vertical keystone will return to the original status.
Adjusting the Projected Image
23