Setting the Jumpers

If you need to change any jumper settings, follow these steps:

1.Refer to the illustration on page 3-6 to locate the jumpers.

2.If there are any option cards installed in your computer, you need to remove them to access the jumpers. See page 3-17.

3.A jumper’s setting is determined by where the jumper is placed on the pins. Use the following table to identify the pin settings for 2-pin, 3-pin, and 4-pin jumpers. To identify pin 1, look at the system board under the jumper. You will see a triangle traced on the board at pin 1.

Installing and Removing Options 3-9