If you are installing a hard disk drive in the upper horizontal bay, make sure you use the proper hard disk drive ribbon cable and connect the ribbon cable to the hard disk drive connector. Also, if this is the second hard disk drive in your system, make sure you set the jumpers on both hard disk drives to indicate which is the master and which is the slave drive. See the documentation that came with your hard disk drive for instructions.

3.Locate one of the power supply cables that lead from the power supply. (They have multi-colored wires and a plastic connector on the end.)

4.Align the notched corners of the power supply cable connector with the notched corners of the drive’s power supply connector (such as the one shown below). Make sure the holes fit over all the pins and then push in the connector.

Caution

If you do not align the cable connectors correctly, you could severely damage your drive when you push them in.

Installing and Removing Drives

4-17