4.Position one of the cache chips over the first socket as shown below, aligning the pins on the chip with the holes in the socket. Make sure the small notch on the end of the chip is aligned with the corresponding notch on the socket.

5.Gently press the chip halfway into the socket (to make sure it is correctly aligned). If the chip goes in at an angle, remove it with a chip puller or a small flat-head screwdriver and try again.

6.When the chip is properly positioned, push down firmly on both ends of the chip to make sure it is well-seated.

Repeat steps 4 through 6 for each of the remaining chips.

Change jumpers J7, JlO, Jll, J13, and J14, as described on page 3-8, to correspond to the amount of cache you installed.

Replace any option cards you removed. See page 3-14 for instructions.

Installing and Removing Options 3-23