■The presentation material may be too far from the lens. Flip down the close-up lens.

■Make sure there is no condensation on the lenses. You may need to wait before using the document camera after moving it from a cold environment to a warm environment.

Switching Between NTSC and PAL

For video output, the document camera is set at the factory to NTSC mode. Follow the steps below to switch to PAL mode.

Before you start, make sure your document camera is plugged in.

1.Make sure the document camera is turned off.

2.Press and hold the Main button on the document camera’s control panel.

Control panel

Main

3.Turn on the document camera.

4.Release the Main button.

The document camera will remain in PAL mode, even after turning it off. To switch back to NTSC mode, repeat the same steps.

Solving Problems 31