35
* This value applies when the zoom ring is turned to the maximum "T" setting.
If the zoom ring is turned to the "W" setting, the available angle of tilt for
automatic adjustment will become smaller.
Tip :
• Automatic keystone correction is not carried out when the "Rear" or "Ceiling"
commands in the "Advanced" menu are set to "ON".
• If you would like to make further adjustments after automatic keystone correction has
been carried out, you can use the [keystone] button on the projector's control panel.
(p.36)
Procedure
While pressing the two foot adjust
buttons at either side, lift up the front
of the projector so that the front
adjustable feet can extend.
Extend the front adjustable feet until the
desired angle is obtained, and then release the
foot adjust buttons.
To retract the front adjustable feet, gently push
down on the projector while pressing the two
foot adjust buttons.
Tip :
• If the projector is tilted horizontally, turn the bases of the front adjustable feet to adjust
the angle.
• When keystone correction is carried out, the projected image will become smaller.
• If the images become uneven in appearance after keystone correction is carried out,
decrease the sharpness setting. (p.47, 48)
• If automatic keystone correction is not required, set "Auto Keystone" in the "Setting"
menu to "OFF". (p.51)
Foot adjust buttons (side)
Extend Retract
Front adjustable
foot