Turning on and Projecting• When using the "Direct
Power ON" feature, the
power turns on when the power cable is connected.
• When using above an altitude of about 1500 m, set the "Fan Speed" to "High".
Control Panel | Remote Control |
| (Accessory |
| Power Cable) |
Power Indicator | * For video equipment, |
| press "play " to start |
| playback. |
● Adjusting Position and Focus ●
(Setting up for the first time or after moving)
■Raising the Projection Position (Adjusting the front foot)
Foot Adjust
Lever
When moving the projector, make sure the front foot is retracted.
Correcting Keystone Distortion
You can adjust the vertical tilt to a maximum of about 30°*(20° when projecting a component video image with a ratio of 16:9).
Wide Top | Normal Wide Base |
English
You can adjust the front foot to raise the projection angle up to a maximum of 10°.
• You can also make keystone
corrections from the configuration menu.
• Hold down and press for more |
than one second to reset the |
correction value to the default |
setting. |
• Adjust the horizontal tilt by turning |
Reading the Indicators 
Lit 
Flashing
Orange Standby
Press 
to start projecting.
● No image is projected ●
■For notebooks and computers with liquid
*The greater the angle of tilt, the harder the image is to focus. Setup the projector at a lower angle of tilt.
■Adjusting Focus
the left rear foot. |
Rear Adjustable
Foot
Extend 
Retract
■Adjusting Projection Size
Enlarge Reduce
In this mode, you can unplug the power cable.
Green Warming up
Wait for a short time (about 30 seconds).
In this mode pressing 
has no effect.
Green Projecting
crystal displays
Change the computerÕs output source. Hold
down the 
key and press the appropriate 
key (the one usually labelled 
/
). After changing the setting, wait a few seconds for projection to start.
Computer’s "User’s Guide"
*If the image is not
projected, press 
.
■ For video equipment
Start playback then press
.
Examples
NEC
Panasonic
SOTEC
HP
TOSHIBA
IBM
SONY
DELL
FUJITSU
Macintosh Set mirror setting or display detection.
After keystone correction and sharpness adjustments, the image may be unfocused.
If keystone correction or zoom adjustments are performed, the "Image Shift" adjustment screen is
displayed.
User’s Guide "Adjusting the Projection Position (Image Shift)"
● Turning the Projector off ●
Turn off all connected equipment.
Press 
twice on the remote control or control panel.
After the confirmation buzzer beeps twice, unplug the power cable.
Electricity is consumed if only the projector's power is turned off.
Attach the lens cover.
* If you turn the power on straight after turning it off, the time before projection starts becomes longer than usual.
ii