Some parallel cables have a ground wire. Connect this wire to the ground screw on the printer to protect data from interference. Then plug the other end of the cable into the computer and connect the ground wire on the computer end of the cable if it has one.

Parallel interfaces require no further adjustment.

The serial interface

For the serial interface, you should use an Epson serial interface cable. Use #8239 for the Apple® IIc, #8297 for the IBM@ PC and compatibles, and #8293 for most other computers with a DB-25 socket, including the Apple IIe with serial interface. (Although you can use the serial interface with an IBM or compatible computer, it is usually best to connect the LQ-2500 to the parallel port of an IBM or compatible computer.)

The serial interface also requires that you change the SelecType Interface setting under *Change Defaults, as well as two other settings, Baud Rate and Parity See the next chapter on SelecType for more information.

10 A Final Checklist

Now that you’ve completed the basic setup and self test, your LQ-2500 is readv to print. If you’ve had any difficulties so far, run down this brief checklist to be sure the printer is properly set up.

Were you able to run the self test successfully? If not, try reloading the paper, and check that all packing materials have been removed from the printer

Is the power source (power strip, etc.) turned on?

Is the ribbon properly installed? Check that the tab on the ribbon cartridge is resting on the support ridge on the carriage. Make sure the pins on the cartridge are in the holes on the carriage.

Before loading continuous-feed paper, read Chapter 3.

1-16

Setting Up the Printer