whenever required, making single sheets as easy and convenient to use as continuous-feed paper. The automatic sheet feeder has its own users manual.

Reloading during printing

When you print a document more than one page long using single sheets of paper, there are two different ways your application program can allow you to load a new sheet at the end of a page.

•If the program sends characters in a continuous stream, the printer stops printing when it reaches the bottom of the paper and sounds the beeper. When this happens, the ON LINE light goes off automatically

•If the program handles printing page by page, it probably stops sending characters at the end of a page and prompts you to insert more paper. In this case the ON LINE light probably remains on, and the first thing you should do is press the ON LINE button once to turn it off.

Once the ON LINE light is off, remove the sheet that has just been printed and load a new sheet in the same way as before.

Loading Continuous-feed Paper

The new push-feed tractor built into the LQ-2500 has several major advantages over other types. It combines the ability to handle a wide range of paper widths with an extremely low profile, and it is easy to load.

The push-feed tractor must be loaded in a slightly different way than the pin-feed system on Epson FX printers and the usual pull-through tractors. If you are used to other systems, follow these instructions carefully

Begin by making sure that the printer is turned off. If you have been using the printer with single sheets, remove the paper guide. You will install it in a different way

3-2

Choosing and Loading Paper