You can switch freely between these settings and mix
pictures of varying quality in the camera. The camera’s
image capacity will vary accordingly.
Flash
PhotoPC 600’s built-in flash is effective within a
range of 20 cm to 2.4 m. Press the flash control
button to cycle through the three flash settings. The
settings appear on the display panel as shown below.
Automatic
The flash fires automatically whenever it is
needed for adequate lighting (factory setting).
Forced flash
The flash fires with every picture you take. Use
this setting to compensate for backlighting; for
example, when you are facing the sun.
Flash off
The flash is disabled, even when adequate
lighting is not available. Use this setting for
special effects, or where flash photography is
prohibited.
Note:
After taking a flash photo, the flash icon blinks until the flash is
fully recharged.
Self timer
Setting the self timer creates a 10-second delay
between the time you press the shutter button and
the actual image capture. This allows you to take a
picture of yourself. The timer icon appears on the display
panel when you use the timer. Follow these steps to take
a picture with the timer:
1. Secure the camera on a flat surface or a tripod.
2. Turn on the camera and wait until the status light turns
green.
Automatic
Forced flash
Flash off
2
R
Poppy Rev.B/TCAT
A5 size Chapter 2
97/09/18 pass 6
Taking Pictures with PhotoPC 600 29