Here’s where you start:
1Click the red button to see what to do next.
2Trim the bottom of the sheet as shown on the screen, then click the red button.
3Peel the backing from the magnet sheet as shown, then click the red button.
4Place the printed sheet on the magnet and position it carefully before you press it down. Then click the red button again.
You see the final screen of instructions:
5Cut out each of your magnets and click the red button. You’re finished!
From here, you can start over again to make a new set of magnets, find out more about refills and other kits, or close the Magnet Kit software.
For Magnet Kit technical support, call (503)