When setting up your printer

Observe the following when setting up the printer:

❏Do not block or cover the vents and openings in the printer.

❏Power supply cords should be placed to avoid abrasions, cuts, fraying, crimping, and kinking. Do not place objects on top of power-supply cords and do not allow the AC adapter or power-supply cords to be stepped on or run over. Be particularly careful to keep all power-supply cords straight at the ends and the points where they enter and leave the AC adapter.

❏Use only the power-supply cords that comes with this product. Use of another cord may result in fire or electrical shock, or injury.

❏The AC adapter model A361H is designed for use with the printer with which it was included. Do not attempt to use it with other electronic devices unless specified.

❏Use only the type of power source indicated on the AC adapter's label, and always supply power directly from a standard domestic electrical outlet with the AC power cord that meets the relevant local safety standards.

❏Avoid using outlets on the same circuit as photocopiers or air control systems that regularly switch on and off.

❏Avoid using electrical outlets controlled by wall switches or automatic timers.

❏Keep the entire computer system away from potential sources of electromagnetic interference, such as loudspeakers or the base units of cordless telephones.

❏Do not use a damaged or frayed power cord, AC adapter, and the optional battery.

❏If you use an extension cord with the printer, make sure that the total ampere rating of the devices plugged into the extension cord does not exceed the cord’s ampere rating. Also, make sure that the total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet’s ampere rating.

English

Safety Instructions

7