Epson TM-C100 manual Hand fed printing is not possible, Paper is not cut roll paper specification

Note:

When using OPOS-X, the option setting is set automatically. Change only the feed setting. (Use the "SlpPaperBinNumber" properties.)

❏Change the driver "Feed setting" to "ASF."

❏Turn off the printer, and reconnect the cable of the ASF unit to the printer. Then turn on the printer again.

❏Check with "ASF Specification" on page A-7that the size of the paper you are using is appropriate for the product specification.

3.4.5Hand fed printing is not possible

If after following "Feeding and printing paper by hand" on page 3-4hand fed printing is not possible, try the following measures again. (For information on how to set the driver, see the driver manual.)

❏Set paper feed in the driver to "Hand feed."

❏If the roll paper holder is attached, remove it.

❏After checking that the PAPER LED flashes after the print command was sent from the driver, set the paper.

❏Check with "Hand Fed Paper Specifications" on page A-9that the size of the paper you are using is appropriate for the product specification.

3.4.6Eliminating excessive bottom margins (roll paper specification)

When using the APD, if you set the "Roll paper saving mode" in the driver, the printer cuts the paper when printing finishes, irrespective of the paper size settings, so that the bottom margin is not excessive. (For information on how to set the driver, see the driver manual.)

Note:

When using OPOS-X, any cut position can be programmed. Note that there is no "Roll paper saving mode."

3.4.7The paper is not cut (roll paper specification)

❏You can use a self-test (see "Self Test Procedure" on page 3-11)to check the operation of the printer. If the paper is not cut after self-testing, the printer may not be working properly. Have it serviced.

❏In the long print mode, the paper is not cut at a new page. Check the driver settings. (For information on how to set the driver, see the driver manual.)

Note:

When using OPOS-X, any cut position can be programmed. Note that there is no "Long print mode."

3-10Using the Printer Rev. C