TM-C100 Technical Reference Guide
A.4 ASF Specification
Item | Specification |
|
|
|
|
Cut sheet feeder specifications | Paper feed type: | Friction feed |
| ASF unit detection: Detection by an optional connector | |
| Cut sheet detection: Detection by the TOF/BOF sensor | |
|
|
|
Paper specifications | Paper type: | Plain paper/special paper (special fine paper, special matte |
|
| paper)/plain borderless label paper |
| Paper size: | 55 to 135 mm (width) × 85 to 210 mm (length) |
| Paper thickness: 0.08 to 0.25 mm | |
| Basic weight: | 64 to 218 g/m2 (JIS P8124) |
|
| (55 to 188 kg / 1,000 sheets / 788 × 1,091 mm) |
|
| |
Feed specifications | Number of sheets set: Combined paper thickness 5.5 mm or less (including | |
|
| unevenness in the paper) |
|
| 20 sheets or less (with paper thickness of 0.25 mm) |
|
| 50 sheets or less (with paper thickness of 0.10 mm) |
|
| |
Mass | Approximately 1.9 kg | |
|
|
|
Note:
The paper must be flat, without curls or wrinkles (especially at the top edges). Otherwise, the paper may rub against the nozzles and be soiled.
When printing envelopes, curls or wrinkles may occur because of the sealing method, shape, material and so on, causing feed and printing errors; therefore prior evaluation is necessary.
In order for cut sheet detection to work properly, do not use paper that has cutouts or holes. However, as shown in the following figure, holes and cutouts of the "permissible hole and cutout size" in the "hole and cutout permissible area" are permissible.
hole and cutout permissible area
hole and cutout permissible size
11 or less
10 or more |
|
|
| feed direction |
|
| |||
8 or less |
|
| ||
|
| |||
3 or more
[Unit: mm, all values are typical]
* Hole and cutout outside the "hole and cutout permissible area" are not
Cut sheet hole permissible area
Rev. C | Product Specifications of the |
