Problem Solving 113
Problems when projection startsNo power supplied
Check Remedy
Did you press the [t] button? Press the [t] button to turn the power on.
Are the indicators switched off? The power cable is not connected correctly or power is not being supplied normally.
Disconnect and then reconnect the power cable.
Check that your electrical outlet or power source is functioning correctly.
Do the indicators turn on and off when the power cable is
touched?
There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the
power cable. If this does not solve the problem, stop using the projector, disconnect the power cable
from the electrical outlet, and contact Epson. sp.116
Is the Control Panel Lock set to Full Lock?Press the [t] button on the Remote Control. If you do not want to use Control Panel Lock, change the
setting to Off. sSettings Menu - Control Panel Lock p.62
Is the correct setting for the remote receiver selected? Check the Remote Receiver from the configuration menu. sSettings Menu - Remote Receiver p.71
Was the power cable plugged back in or was the breaker
turned on immediately after Direct Power Off?
Even when Direct Power On is set to On, the power may not turn back on in these instances. Press the
[t] button to turn the power back on.
Is the ID switch on the side of the remote control set to On? When the switch is set to On, you can use the remote control to operate only a projector with a matching
ID. Set ID switch to Off sp.55
Are the lamp cover and lamp installed correctly? If the lamp or lamp cover is installed incorrectly, the projector cannot be turned on. Check how it is
installed.