Security Functions 61
Procedure
ADuring projection, hold down the [Freeze] button for about
five seconds.
The Password Protect setting menu is displayed.
If Password Protect is already activated, you must enter the Pass-
word. If the Password is entered correctly, the Password Protect
setting menu is displayed. s"Entering the Password"
When the Password is set, stick the Password protect sticker in a
visible position on the projector as a further theft deterrent.
BTurn on Power On Protect.
CTurn on User's Logo Protect.
DTurn on Network Protect.
ESet the Password.
Remote Control
(1) Select Power On Protect, and then press the [Enter] button.
(2) Select On, and then press the [Enter] button.
(3) Press the [Esc] button.
(1) Select User's Logo Protect, and then press the [Enter] button.
(2) Select On, and then press the [Enter] button.
(3) Press the [Esc] button.
(1) Select Network Protect, and then press the [Enter] button.
(2) Select On, and then press the [Enter] button.
(3) Press the [Esc] button.
(1) Select Password, and then press the [Enter] button.
(2) The message "Change the password?" is displayed, select Yes
and then press the [Enter] button. The default setting for the
Password is "0000". Change this to your own desired Password. If
you select No, the screen shown in step 1 is displayed again.
(3) While holding down the [Num] button, enter a four digit number
using the numeric buttons. The number entered is displayed as "*
* * *". When you enter the fourth digit, the confirmation screen is
displayed.
Remote Control
(4) Re-enter the Password.
The message "Password accepted." is displayed.
If you enter the Password incorrectly, a message is displayed
prompting you to re-enter the password.