Epson Z8000WUNL, Z8050WNL Changing the Projected Image

Changing the Projected Image 44
Procedure
When your video equipment is connected, start playback before
beginning this operation.
When two or more pieces of equipment are connected, press the [Source
Search] button until the target image is projected.
The following screen showing the status of image signals is displayed
when only the image that the projector is currently displaying is
available, or when no image signal can be found. You can select the input
port where the equipment you want to use is connected. If no operation
is performed after about 10 seconds, the screen closes.
LAN is only displayed when you are using the PowerLite Pro
Z8050WNL.
Switch to the target image using the Remote Control
You can change directly to the target image by pressing the following
buttons on the Remote Control.
Using the Remote Control Using the Control panel Remote Control
1 Changes to images from the Computer input port.
2 Changes to images from the Video input port.
3 Changes to images from the S-Video input port.
4 Changes to images from EasyMP Network Projection (PowerLite
Pro Z8050WNL only). This button does not function when you are
using the PowerLite Pro Z8000WUNL.
5 Each time the button is pressed, switches between images from
the DVI-D and HDMI input ports.
6 Changes to images from the BNC input port.