Ericsson LBI-38377E manual TX Transmitter enabled On when the radio is transmitting

T99 Type 99 tone decode - On indicates Type 99 tone decoding is enabled on the se- lected channel. Flashing indicates a T99 selective call has been received and the radio must be reset to receive another T99 call.

TX Transmitter enabled - On when the radio is transmitting.

BSY BuSY - On indicates a carrier is being received (the channel is busy). Note that if the selected channel is programmed for Channel Guard (CG), Digital Channel Guard (DCG), or Type 99 (T99) tone de- code operation, the radio will not un- squelch if a valid tone or code is not received; the BSY status flag will be on.

CG Channel Guard - On indicates tone Chan- nel Guard (CG) or Digital Channel Guard (DCG) encode/decode is enabled on the selected channel.

BAT BATtery low - On indicates the battery pack’s charge is low.

The following status flags are for use with Scan and System model radios:

SScan list - On indicates the selected chan- nel is on the scan list.

1priority 1 - On indicates the selected chan- nel is designated as the priority-one scan channel.

2priority 2 - On indicates the selected chan- nel is designated as the priority-two scan channel.

SCN SCaN mode - On indicates the radio is scanning.

UNIVERSAL DEVICE CONNECTOR

The Universal Device Connector (UDC) is lo- cated on the side of the radio just above the PTT and MONITOR BUTTONS. This connector provides con- nections for the external accessories such as a head- set, a speaker-mike, or an emergency lanyard. When the radio is locked in a vehicular charger/repeater the UDC provides the audio and control connections between the radio and the vehicular charger/re- peater. The UDC is also used by the maintenance personnel when the radio is programmed.

14