Intrinsically Safe Usage, Batteries | Ericsson LBI-38377E instruction

Figure 10 - Swivel Mount Removal and Replacement

INTRINSICALLY SAFE USAGE

Selected portable radios with appropriate factory installed F4 Options are certified as Intrinsically Safe by the Factory Mutual Research Corporation. Intrin- sically Safe approval includes Class I, II, III, Division 1 hazardous locations in the presence of Groups C,

D, E, F and G atmospheres. Non-Incendive approval includes Class I, Division 2 hazardous locations in the presence of Groups A, B, C, and D atmospheres.

Hazardous locations are defined in the National Electrical Code. Useful standards NFPA 437A and NFPA 437M for the classifications of hazardous areas may be ordered from the National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.

BATTERIES

Only batteries identified with a green latch shall be used with a portable radio that is rated and labeled as Factory Mutual Intrinsically Safe. Use of nonspe- cified batteries voids Factory Mutual approval. The following battery pack options are approved for use in intrinsically safe radios:

∙ PAPA1F Rechargeable Battery, Extra High Capacity (Tall Case)

∙ PAPA1G	Rechargeable Battery, High Ca-
	pacity (Short Case)

31

Image 31

Ericsson LBI-38377E manual Intrinsically Safe Usage, Batteries, Pacity Short Case

Contents

Operator’s Manual Ericsson Inc Table of Contents TTD Safety Not Applicable Control Knob Controls ON/OFF SwitchVolume Control Knob Introduction Monitor Button PTT ButtonEmergency Button PA Personal Radio Side View Front View KEY Lock Allows the keypad buttons to be locked or unlocked Alert Allows the alert tones to be dis- abled or enabledMenu Button Scan Model Menu Display Mode Exit ButtonScan Button Channel PA System Model Radio Select Button Dtmf Keypad Indicators Universal Device Connector TX Transmitter enabled On when the radio is transmitting Channel Busy Carrier Control TimerOperation POWER-UP Alert Tones MODE/CHANNEL/CG Selection Press the Menu button until Mode ap- pears in the displayPress the Menu button until Channel appears in the display Receiving a Message Adjust the volume as necessary Listen for a reply Transmitting a Message Press the Menu button until Scan A/D is displayed Adding Channels To And Deleting Channels From The Scan List Scan Model Using ScanScan DIS - The radio is not programmed to scan Telephone Interconnect Calls Press the Menu button until Phone ap- pears in the display If the SCN status flag is on, press Scan to turn scan off Placing a Manually Dialed Call Telephone Interconnect Calls System ModelsPress and hold the PTT Button to key the transmitter Placing An Automatically Dialed Call Release the PTT Button when the dial sequence is completeWhile holding the PTT BUTTON, press Release the PTT Button and listen for a dial tone KEY Lock Menu Scan and System models Lock The Keypad Unlock The Keypad Disable The Alert TonesEnable The Alert Tones Programmable Features Radio Programmable Programmable by Channel Operating Tips When using your two-way radio, remember these rules Battery Packs Installing the Battery Pack Removing the Battery Pack Installing the Battery Pack Contains a rechargeable, recyclable Swivel Mount Removal Replacement Batteries Intrinsically Safe UsagePacity Short Case Accessories Warranty Warranty becomes void if NICKEL-CADMIUM Battery WarrantyPage Emergency Numbers