MODE/CHANNEL/CG Selection | Ericsson LBI-38377E instruction

If programmed on, the power-up alert tone (beep) will be heard.

MODE/CHANNEL/CG SELECTION

The M-PA Scan and System model radios may be programmed with up to 192 different radio chan- nels. A maximum of 12 modes of 16 channels each or 16 modes of 12 channels each may be pro- grammed into the radio (12 x 16 = 192). Select the desired mode (bank of channels) and channel, or channel and Channel Guard (CG), according to the radio’s programming as follows:

MENU And SEL Selects Mode

CONTROL KNOB Selects Channel (And CG)

1.Press the MENU button until "MODE" ap- pears in the display.

2.Press the SEL button to select the desired mode. The selected mode’s name will ap- pear in the display.

3.Press the EXIT button to switch radio opera- tion to the selected mode and exit the menu.

4.Select the desired channel by rotating the CONTROL KNOB until the desired chan- nel’s name appears in the display.

CONTROL KNOB Selects Mode

MENU And SEL Selects Channel (And CG)

1.Select the correct mode by rotating the CONTROL KNOB until the desired mode’s name appears in the display.

2.Press the MENU button until "CHANNEL" appears in the display.

3.Press the SEL button until the desired chan- nel’s name appears in the display.

4.Press the EXIT button to switch radio opera- tion to the displayed channel and exit the menu.

MENU and SEL Selects Modes And Channels CONTROL KNOB Selects Channel Guard

1.Press the MENU button until "MODE" ap- pears in the display.

16

Image 16

Ericsson LBI-38377E manual MODE/CHANNEL/CG Selection, Press the Menu button until Channel appears in the display

Contents

Operator’s Manual Ericsson Inc Table of Contents Safety Not Applicable TTD Controls ON/OFF Switch Volume Control KnobIntroduction Control Knob Monitor Button PTT ButtonEmergency Button PA Personal Radio Side View Front View Alert Allows the alert tones to be dis- abled or enabled Menu Button Scan ModelMenu Display KEY Lock Allows the keypad buttons to be locked or unlocked Exit Button Scan ButtonChannel Mode PA System Model Radio Select Button Indicators Dtmf Keypad TX Transmitter enabled On when the radio is transmitting Universal Device Connector Carrier Control Timer Operation POWER-UPAlert Tones Channel Busy MODE/CHANNEL/CG Selection Press the Menu button until Mode ap- pears in the displayPress the Menu button until Channel appears in the display Adjust the volume as necessary Receiving a Message Transmitting a Message Listen for a reply Adding Channels To And Deleting Channels From The Scan List Press the Menu button until Scan A/D is displayed Using Scan Scan DIS - The radio is not programmed to scanTelephone Interconnect Calls Scan Model If the SCN status flag is on, press Scan to turn scan off Press the Menu button until Phone ap- pears in the display Placing a Manually Dialed Call Telephone Interconnect Calls System ModelsPress and hold the PTT Button to key the transmitter Release the PTT Button when the dial sequence is complete While holding the PTT BUTTON, pressRelease the PTT Button and listen for a dial tone Placing An Automatically Dialed Call Lock The Keypad KEY Lock Menu Scan and System models Disable The Alert Tones Enable The Alert TonesProgrammable Features Unlock The Keypad Programmable by Channel Radio Programmable When using your two-way radio, remember these rules Operating Tips Battery Packs Installing the Battery Pack Installing the Battery Pack Removing the Battery Pack Swivel Mount Removal Replacement Contains a rechargeable, recyclable Batteries Intrinsically Safe UsagePacity Short Case Accessories Warranty NICKEL-CADMIUM Battery Warranty Warranty becomes void ifPage Emergency Numbers