number from the special call list, if no special calls are programmed then this field will be blank. Note this display is similar to the Special Call mode display except the "S" and "PC" icons are not illuminated.
2.The programmed call may now be sent following the procedure de- scribed in the section for the SCAN Model Radio.
Sending A Manually Entered Individual Call
1.Press the SPC key to put the radio into Special Call mode or "7" to put the radio into Conference Call mode. The SYStem field will display "SP" and the GRP (Group) field will display the last accessed call number from the preprogrammed Special Call selection. or will be blank if no Special Calls are programmed for this area. If the radio was put into Special Call mode the "S" and "PC" icons will be illumi- nated and if the radio was put into Conference Call mode the icons will be off.
2.Enter the tone set of the radio to be called. The first digit entered will cause the System field and the 10’s digit in the Group field to blank. The last digit entered will always be displayed in the 1’s digit of the Group display. Any previously entered digits will scroll left. Only four characters will be visible at a time with the leading character scrolling off the display upon each new key entry.
NOTE
To recall the last individual number entered manually from the key pad, press and hold the SHFT/CLR button and then press the RCL key.
3.Complete the tone set entry by pressing the # key. The # key indicates the digits entered are for an individual call. This will not be displayed but a tone will sound.
45
