Power

1.The Estate Swing E-SC 1602 comes with 1) 24V transformer. The transformer sup- plied has 2 screw terminals to connect to. You may locate the transformer up to 1000’ away from the control board using wire ratings as specified below.

•0-99 Feet - Use 16 Gauge, 2 Conductor Stranded Direct Burial Wire

•100-299 Feet - Use 14 Gauge, 2 Conductor Stranded Direct Burial Wire

•300-599 Feet - Use 12 Gauge, 2 Conductor Stranded Direct Burial Wire

•600-1000 Feet - Use 10 Gauge, 2 Conductor Stranded Direct Burial Wire

2.Insert the two wires from the transformer into the two VAC terminals on the control board (CN1). The wires are not polarized, there is no positive or negative. Do not splice the power cable wire.

Never run 110VAC power directly to the Estate Swing. This will destroy the Estate Swing control board.

Never connect the power wire with the transformer plugged in. Contact between the two lead wires, even for a second, will destroy the transformer.

3.Plug the transformer into a 110 V AC outlet.

4.The transformer is not weather proof and must be kept in a covered area. Plug covers are available from your dealer, contact 1-800-640-GATE for a dealer in your area.

5.Two 12V DC batteries may be run in series as backup to the 24V transformer power. Running two 12V batteries in series creates a 24V system, you can- not run them in parallel (see diagram to the left)

6.The power light located below the +24V and –24V output terminals will be on if the power is connected properly. If the light is off then power through the transformer is not functioning properly and either the unit has no power or is on battery backup. The light stays off during battery backup.

4.8