5.When the closing stop point or limit switch is reached, the motor pauses for approximately 2 seconds, and then restarts with a total opening maneuver to the opening stop point or limit switch.

6.When the full open stop or limit switch is reached the doors will stop.

7.Wait for the amount of time you would like your doors to pause for during normal operation before automatically re-closing and then signal your opener using an OPEN A contact or trans- mitter signal to close the doors. The doors will then return to closed and programming will be complete.

(Even if your auto close is off you must still set a pause time, the pause time will not be used in normal door operation.)

Dual doors are programmed simultaneously. Move both of the leafs to the same starting position and both leafs will move together through the same programming sequence. There is a slight starting delay on the slave side.

5.5