Needed Tools

• Power Drill and appro-

 

•

Phillips Head Screw-

 

priately sized bits.

 

 

driver

•

Crescent Wrench

 

•

Tape Measure

•

Flat Head Screwdriver

 

•

Level

•

Nuts, Bolts, Anchors

 

•

Wire Strippers

 

and Washers (see below)

 

•

C-clamps

•

C-Ring Pliers

 

•

Carpenters Clamps

 

 

 

 

 

 

 

 

 

 

Other items that may be needed prior to commencing installation.

•Start and stop post, bracket or door stop. Although the Estate Swing E-SC 1602 features soft start/stop and can be used with limit switches (not included), it is possible to use the E-SC 1602 without limit switches, relying on the positive stops to determine end posi- tions.

•16, 14 or 12 gauge, 2 conductor stranded direct burial low voltage wire will be re- quired to run power to your operator. Length is determined by distance between trans- former power supply and the control box.

•A voltage meter and digital camera may be necessary to run diagnostic checks.

•4 - 3/8” Red Heads, Lag Screws and Shields, or another brand wall mounting 3/8” bolt and anchor will be needed to connect the Base Plate to the wall.

•2 - 5/16” Hex Bolts will be needed to connect the Door Mounting Bracket to the door. Length will be determined by what is needed for a secure anchor.

•If your transformer is going to be plugged into an outdoor outlet you will need to weather- proof that outlet and transformer. Electrical boxes or plug covers can be obtained from a local hardware store to accommodate both the plug and transformer.

• Hardware to attach the control box to a wall.

1.4

 

•Watertight connectors for running wires into the control box.