Eureka 2940 manual Parts List FIG, HOW to Assemble, Position before plugging

ENGLISH

	PARTS LIST (FIG. 1)
	A
	● Wand and crevice wand (pull apart)
	B
	● Dusting brush
	C
	● Hose
●	D
	E
G	● Vacuum cleaner body
	● Electrical cord
H	F
	● Handle
●	G
	● Self-cleaning duster
	H
	● Turbo tool (some models only)
	I
	● Screws located in the accessory package

	●			HOW TO ASSEMBLE
	D			CAUTION: Assemble the cleaner before using.
	●
●	C			CAUTION: Moving parts. Make sure ON/OFF switch is in the OFF
A		●
		E		position before plugging in.
				F
				Step 1: Slide the handle ● into the grooves at the top of the vacuum
				D
				body ● as shown (FIG. 2).
				Step 2: Place the two screws (supplied) into the holes at back of the unit
				and tighten with a screwdriver (FIG. 2).
				E	J
	B			Step 3: Pull the electrical cord ● up to the cord retainer ● and firmly
				push down into retainer. This will keep the cord out of the way
	●
				the next time you vacuum (FIG. 3).
				K
	●			Step 4: Wind the cord around the two cord hooks ● on the back of the
				vacuum (FIG. 3).
	F
				Step 5: Secure plug to the cord to prevent unwinding (FIG. 3).
				C
			FIG. 1	Step 6: Place the hose ● on the back of the vacuum, wrapping it up
				and over the hose hook as shown (FIG. 4).
	●
				●	to the hose
	J			Step 7: Secure the bottom of the self cleaning duster G
	E			retainer. Firmly push the end of the hose into the top of the self
	●			cleaning duster (FIG. 4).
				A
				Step 8: Store the wands ● on the side of the vacuum in front of the
	●			hose (FIG. 5).
				B
	F			Step 9: Store the dusting brush ● on its holder (FIG. 6).
●			●
D
			K

	●
	K
FIG. 2	FIG. 3
C	●
●	B
	●
	A

●G

6 FIG. 4

FIG. 5

FIG. 6