Euro-Pro EP825 owner manual Operating Instructions, Attachment USE Chart, Motor Thermostat

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS

5. Changing the Head Light Bulb:

Warning: Always disconnect from power source when servicing or cleaning the unit. Failure to do so

could result in electrical shock or personal injury from cleaner suddenly starting.

•Turn unit “Off” and unplug from wall outlet.

•Insert the edge of a flat edge screw driver into the locking tab on the headlight lens and pull the handle of the screw driver towards you. Do NOT push with the blade of the screw driver against the lens because it might cause it to break.

•Remove the lens. (Fig. 12)

•Remove the light bulbs by pulling them out carefully.

•Push the new light bulbs in and replace the lens cover.

•Make sure that it snaps in place.

Note: Always replace the light bulb with the same or smaller wattage size (12V 4W) to prevent damage to the surrounding parts.

Motor Thermostat

Important: This unit is equipped with a motor protective thermostat. If for some reason the vacuum cleaner should overheat, the thermostat will automatically turn the unit off. Should this occur:

•Push the On/Off button once.

•Disconnect the plug from the power source.

•Check the source of overheating problem. (i.e. clogged hose or filter)

•If clogged hose or filter is found, unclog the hose and replace the filters.

•Wait at least 45 minutes before attempting to reuse the vacuum.

•After unit has cooled down for

45 minutes, plug in the cleaner and push the On/Off button. The vacuum should start again.

•If the vacuum still does not start, contact customer service at 1-800-798-7398.

Using the Attachments

Warning:

•Always turn vacuum "Off" before attaching the accessories.

•Do NOT place hands or feet underneath the agitator brush at any time. When using the attachments, the agitator brush continues to rotate.

•Do NOT allow the vacuum cleaner to remain in just one place for a long period of time as the agitator may damage the floor surface.

•NEVER place the vacuum cleaner on furniture, the fringed area of rugs, deep pile carpeting or carpeted stairs. The ideal position for the vacuum cleaner when using any attachment is for the unit to be on a level surface with the handle in the upright position and the carpet height adjustment knob in HIGH.

1.Place vacuum in its upright position.

2.Make sure that the vacuum cleaner is NOT plugged into the electrical outlet.

3.Turn the carpet adjustment knob to the high pile position.

4.Pull the hose connector from the rear of the vacuum and push the desired attachment firmly onto the end of the hose. (Fig. 3)

5.If additional length is required, attach one or both of the extension tube to the end of the hose and then attach the crevice tool or dusting brush to the end of the extension tube.

Extension

Tube (2)

Crevice

Tool

Dusting

Brush

Hose

Connector

Fig. 3

WARNING: When the vacuum is turned on, the beater brush will continue to rotate. Avoid tipping

the vacuum or setting it on furniture, fringed area rugs or carpeted stairs while you are using the hose with the attachments. Avoid leaving the vacuum is one place for an extended period of time, particularly on thick carpet.

IMPORTANT: If the bag is not inserted correctly into the housing, the cover will not close. Please make sure that the bag is inserted all the way in until the latch catches otherwise front cover will not close.

Fig. 12

Lens locking tab

7

ATTACHMENT USE CHART

			CLEANING AREA
ATTACHMENT	Furniture	Between		Drapes	Stairs	Walls
		Cushions
DUSTING	*			*	*	*
BRUSH
CREVICE	*	*			*
TOOL

4