Press the Monitor window button, it will open showing a pull down set of physical port numbers.
Choose the wanted port, for your testing. Enter the desired phone number in the field named Enter the dial number
below and press the 
button. In few seconds the GSM phone shall ring and after call accepted, check the voice call operating properly, between the attached
In case of failure it might be that:
∙GSM signal is too low
∙The GSM modules are not compatible with the GMS network around.
∙The SIM installed is not compatible with the
Note: We are using SIM of 3V only (5V SIMs or other voltage will not work).
∙The SIM card used requires a pin code.
In case you still have errors to operate the system it is recommended to review the “Getting Started״ chapter tasks and make sure you did follow the instructions properly.
Still you have problems after doing the “Getting Started״ tasks list review above your shall refer to Chapter 12: Troubleshooting and known issues.
WARNINGS!
∙The call is NOT FREE and will be charged from the SIM registered billing account, by your GSM supplier!
∙Press “Logout״ button to terminate the call and to exit from the test mode.
PRI – GSM | 38 |
