EverFocus EZ630 manual Osd Menu Setup, Control Key General Operation Guide, Chapter

Chapter

3 OSD MENU SETUP

3

This chapter introduces how to change RS485 ID and Baud Rate and to configure the camera OSD menu.

STEPS

If you want to connect to the camera with a keyboard or other RS-485 - controller, please refer to Section 3.2 RS485 ID & Baud Rate setting. Otherwise, please go to STEP 2.

Configure the camera, as described below:

3.1 Control Key General Operation Guide

Switch between Lens and Menu operation

Press and hold ( ~ 5 s) the joystick button for changing the operation mode of the joystick. Red LED: Menu mode, Green LED lens control mode.

Bring Up the General OSD Menu

Simply press the mini-joystick to bring up the general OSD menu.

Note: Make sure, that the joystick is in "MENU" mode (red LED under Joystick).

Navigate among the OSD Menu Items

Angle the mini-joystick up (￿) or down (￿) to move the cursor up or down.

Change Modes or Setting Parameters

Angle the mini-joystick left (￿) or right (￿) to adjust the mode or value of settings.

Switch to Sub-menu Screens

When an item with a sub-menu is selected, press in on the mini-joystick to switch to the sub-menu for further settings. This may also be referred to in the instructions below as “pressing the setup button”. Please refer to the diagram below.

SETUP	EVERFOCUS
1. LENS	DC	<	DC LENS
2. EXPOSURE
3. WHITE BAL.	AWB		￿BRIGHTNESS +++++++++ 45
4. DAY NIGHT	EXT
5. 3DNR	ON	<	RETURN RET
6. SPECIAL
7. ADJUST			Sub-Menu
8. RESET	<
	Main Menu

9. EXIT

18