either the mower blades are engaged, or the transmission shifter lever is not in neutral and the operator removes both hands from the handles, the mower engine must stop.
b)To determine if the OPC is in operating condition, clear area of bystanders. Run the engine at
Again, run the engine at
If the mower engine does not stop under any of the
above mentioned conditions, DO NOT OPERATE. Contact your authorized Exmark service dealer.
•It is essential that all Operator Safety Mechanisms, be in place and in proper operating condition prior to mowing.
5.1.5Check Brake and Wheel Drive Linkage Adjustment.
Service Interval: Daily
Refer to Sections 3.8.5 and 3.8.6. Note any bent linkage or hardware which may need servicing or replacing.
5.1.6Check for loose hardware.
Service Interval: Daily
a)Stop engine and remove spark plug wire(s).
b)Visually inspect machine for any loose hardware or any other possible problem. Tighten or replace any hardware before operating.
5.1.7Service
Service Interval: See Engine Owners Manual
a)Stop engine and remove spark plug wire(s).
b)See engine owners manual for cleaning instructions.
5.1.8Change engine oil.
Service Interval: See Engine Owner's Manual
NOTE: Change oil after first five (5) hrs. of operation. Follow engine manufacturer's recommendations for future oil changes.
a)Disengage blades.
b)Stop engine and remove spark plug wires(s).
c)Drain oil while engine is warm from operation or if oil is to be changed after the unit has been sitting for awhile, run engine for a few minutes to get it warm.
•Do Not service or make repairs near the engine area when the engine is hot.
d)Remove the oil drain plug from the right hand side of the engine. Allow oil to drain, replace drain plug.
e)Replace the oil filter per the engine owners manual (Kohler and Kawasaki only, there is no filter on B&S
- 22 -
