DANGER
POTENTIAL HAZARD
♦Adjusting the cutting height levers could bring your hands into contact with a moving blade.
WHAT CAN HAPPEN
♦A moving blade can cause serious injury.
HOW TO AVOID THE HAZARD
♦Stop the engine and wait for all movement to stop before adjusting the cutting height.
♦Do not put your fingers under the housing when adjusting the cutting height.
1.Pull the wheel height adjustment lever toward the wheel (Fig. 16) and move it to the desired setting.
Figure 16
2.Release the wheel height adjustment lever and set it securely in the notch.
3.Adjust all the wheels to the same cutting height setting.
4.3.9Using the Grass Bag
Occasionally, you may wish to use the grass bag for bagging extra long grass, lush grass, or leaves.
Installing the Grass Bag
1.Stop the engine and wait for all moving parts to stop.
2.Ensure that the discharge door handle is fully forward and that the pin is engaged in the catch (Fig. 17).
Bag Frame on |
|
Retaining Post | Pin Engaged in Catch |
Handle fully Forward
Discharge Door Closed
G0211
Figure 17
3.Slide the hole in the bag frame onto the retaining post on the discharge tunnel (Fig. 17)
4.Set the rear of the bag frame onto the bag support rod.
5.Pull the discharge door handle forward until the pin clears the catch, and move the handle rearward until the pin locks in the bag notch (Fig. 18).
-18 -
