Exmark Metro 21 Series manual Bag Support Rod Handle Latch Mounting Hole Location

NOTE: You can adjust the handle height for comfortable operation. Stand behind the handle to determine the height. To adjust the handle height, position the carriage bolts into the upper, middle, or lower mounting holes in the handle latches and secure with the black knobs.

3. For units with Honda Engines: Slide the bag support rod through the bag alignment plate and into the upper, middle, or lower mounting holes in the handle and secure each end with a cap locknut (Fig. 1). The bag support rod mounting hole location corresponds with the mounting hole location for the handle latches as shown in the table below.

Bag Support Rod	Handle Latch
Mounting Hole Location	Mounting Hole Location
Lower	Lower
Middle	Middle
Upper	Upper

Secure the top of the bag alignment plate with a carriage bolt and cap locknut (Fig. 1).

For units with Kawasaki Engines: Slide the bag support rod into the upper, middle, or lower mounting holes in the handle and secure each end with a cap locknut (Fig.

1). The bag support rod mounting hole location corresponds with the mounting hole location for the handle latches as shown in the table above.

4. Use a cable tie to secure the control cables to the left handle below the bag support rod.

Figure 1

3.2Installing the Starter Rope (Units without a Blade Brake Clutch Only)

1. Pull the starter rope from the engine through the rope guide on the handle (Fig 2.).

Rope Guide

Starter Rope

Figure 2

- 9 -