Extreme Networks 200 Series Making Changes to a Routing Access Policy, Removing a Routing Access Policy

132 Summit 200 Series Switch Installation and User Guide
Access Policies
Figure 23: OSPF access policy example
To configure the switch labeled Internet, the commands would be as follows:
create access-profile okinternet ipaddress
config access-profile okinternet mode permit
config access-profile okinternet add 192.1.1.0/24
config ospf asbr-filter okinternet
Making Changes to a Routing Access Policy
You can change the routing access policy by changing the associated access profile. However, the
propagation of the change depends on the protocol and policy involved. Propagation of changes
applied to RIP access policies depends on the protocol timer to age-out entries.
NOTE
Changes to profiles applied to OSPF typically require rebooting the switch, or disabling and re-enabling
OSPF on the switch.
Removing a Routing Access Policy
To remove a routing access policy, you must remove the access profile from the routing protocol or
VLAN. All the commands that apply an access profile to form an access policy also have the option of
choosing none as the access profile. Using the none option removes any access profile of that particular
type from the protocol or VLAN, and, therefore, removes the access policy.
Internet
Backbone (OSPF)
area 0.0.0.0
Sales
area 0.0.0.2
Engsvrs
area 0.0.0.1
10.0.0.10 / 24
10.0.0.11 / 24
10.1.1.1 / 24 10.2.1.1 / 24
10.0.0.12 / 24
Switch being
configured
LC2401
2