Extron electronic 325 Device summary panel , Licensed features panel

Device summary panel
This panel consists of the following fields:
• Name — This field displays the name of the
device. You can change the name of the
unit to a more meaningful value for your
installation as follows:
1. Highlight the existing device name.
2. Type the new name. |
3. Click the update button.
NOTE: Spaces within names can cause issues when controlling the system
using a third-party control system. Extron recommends avoiding spaces
within names..
• Serial Number — This read-only field displays the serial number of the device,
information is required when upgrading the licence on a device.
• Device Status — This read-only field displays either of the following messages:
• Active — The device is present and operating.
• Inactive — The controller cannot contact the device. It may be powered down or
the network cable is unplugged.
• IP address: port — This read-only field displays two pieces of information:
• The IP address that is assigned to LAN port 1.
• The port numbers that have been configured for send and receive of UDP control
information. By default these are 9001 (send) and 5432 (receive).
• Link Status — This read-only field displays the condition of the Ethernet network link to
the controller in one of the following messages:
• Good — There is little or no control data packet loss.
• Fair — There is a small amount of control data packet loss.
• Poor — A bad network link exists.
Licensed features panel
This panel consists of the following read-only
fields, which provides a description of features
that are enabled on the device:
• Video — For the VNC 325, this field always
reads 3G-SDI.
• Audio — For the VNC 325, this field always reads 16.
The licence management button opens the License page where additional features may be
enabled.
VN-Matrix 325 Serial Digital Over IP CODEC • Operation 35