Extron electronic 325 Reference Information

Reference Information

This section discusses the specifications, part numbers, and accessories for the

VNC 325 codec. Topics that are covered include:

• Specifications

• Part Numbers and Accessories

• Mounting the Codec

• Test Pattern

Specifications

Video

Signal type ..................................... SDI, HD-SDI, 3G-SDI digital video

Resolution ...................................... 8 or 10 bits, automatic

Data rates ...................................... 270 Mbps, 1.485 Gbps, 2.970 Gbps.

Operation standards ....................... SMPTE 259M, SMPTE 296M, SMPTE 424M

Auto data rate lock ........................ Yes

Video input and loop through — encoder

Number/signal type ........................ 1 digital component video with loop through

10 bit, 4:2:2, with auto-detection

Connectors .................................... 3 female BNC: 1 for input, 2 for loop through (1 with messaging overlay option)

Nominal level ................................. 0.8 Vp-p

Impedance ..................................... 75 ohms

Data rates ...................................... 1.5 Gbps to 3.0 Gbps

Vertical frequency ........................... 23.97 Hz to 60 Hz, depending on signal format

Resolution range ............................ 525i, 625i, 720p, 1080i, 1080p, 1080psf

Video processing — codec

Compression .................................. PURE3® Codec

Frame rate delay ............................. 35 ms (70 ms encoding/decoding end-to-end)

Bit rate ........................................... 6 Mbps to 250 Mbps

Bit and frame rate control .............. Selectable

Frame rate ...................................... Up to 60 fps @ 1080p

Video output — decoder

Number/signal type ........................ 1 digital component video

10 bit, 4:2:2, with auto-detection

NOTE: Output signal format follows the input format at the encoder.

Connectors .................................... 1 female BNC

Nominal level ................................. 0.8 Vp-p

Impedance ..................................... 75 ohms

Vertical frequency ........................... 23.97 Hz to 60 Hz, depending on signal format

VN-Matrix 325 Serial Digital Over IP CODEC • Reference Information 66

Contents

Main Caution Warning Attention Avertissement Safety Instructions English Consignes de Scurit Franais Sicherheitsanleitungen Deutsch Achtung Vorsicht FCC Class A Notice Conventions Used in this Guide Copyright Trademarks Contents Introduction ............................................1 Installation and Setup ............................ 5 Operation ...............................................31 Alarms and SNMP ..................................59 Page Introduction Page Features Page Installation and Setup Installation and Setup Overview Rear Panel Features a b c d e f g h Network Netw Page Page Example 1: Switched and isolated network configuration Page Example 2: Switched and isolated network configuration Page Example 3: Routed Network Configuration Configuring Network Settings Serial Port Wiring Low-level Network Configuration Page Configuration Selections Making Remaining Connections RS-232 Over LAN Port LAN Ports d e RJ-45 port wiring Video Input, Output, and Loop Connections Encoder configuration a b c Network Decoder configuration a b Configure Encoders and Decoders Startup and Login Page Configure the Units as Encoders or Decoders Page Page Enable multicast streaming Operation Indications and Controls a b c Network Interface Device List Page Device Field Device Mode Removing a device from the network Page Device summary panel Licensed features panel Device setup panel Configuration panel Configuration Page Video Encoder Streams panel Configuration Page Audio Encoder Name panel ANC (Audio) panel Forward error correction (FEC) panel Streams panel Configuration Page Colfec and Rowfec Encoders Bandwidth Management Page and Typical Bit Rates a b Bandwidth management standard controls panel Advanced Controls panel Typical bit rates Decoder Display and Configuration Page a b Decoder Video Configuration Panel Decoder Streams Configuration Panel Decoder Bit Rate and Stream Page a b c d e Dropped packets row Displays the number of data packets dropped during the G Page Configuring a Serial Pass-through Group Firmware Upgrade Page Uploading the upgrade to the controller codec Installing the firmware (prepare, activate, and commit stages) License Page Accounts Page (Passwords and Clock Management) Passwords Panel Clock Management Panel Controller Licensing Panel Alarms and SNMP Alarms Alarms Page Filter settings panel a b c d e Alarm list panel Alarm types and descriptions Page Alarm Logs page Simple Network Management Protocol SNMP Password Value Page Reference Information Specifications Video Video input and loop through encoder Video processing codec Sync genlock decoder Audio input and output NOTE: Audio processing Control host ports codecs, decoders Network transport General Specifications are subject to change without notice. Part Numbers and Accessories Codec Part Number and Included Parts Mounting and Power Options Optional SFP Module Cables Mounting the Codec Tabletop Use Mounting kits UL Rack-Mounting Guidelines Test Pattern Extron Warranty