Configuration Page — Video Encoder
The video encoder configuration page (see figure 26) is accessed by clicking the video
icon in the configuration panel of the device page and consists of two panels. This page
also provides access to the bandwidth management page via the Bandwidth tab (see
“Bandwidth Management Page and Typical Bit Rates“).
1
2
Figure 26. Video Encoder Configuration Page
The top panel of the video encoder configuration page (a on figure 26) provides the
following information:
• Name — This field displays the name that is applied to the video port, that is, the name
of the image stream. The name is displayed next to the video icon in the configuration
panel of the device page. Note that this need not be the same as the name applied to
the physical unit itself. You can change the name to a more meaningful value for your
installation. Change the device name as follows:
1. Highlight the existing device name.
2. Type the new name.
3. Click the update button.
NOTE: Spaces within names can cause issues when controlling the system
using a third-party control system. Extron recommends avoiding spaces
within names..
• Input Mode — The VN-Matrix 325 codec supports a fully automatic detection of the
connected signal format. No manual configuration is required.
• Current Mode — This value reports the currently detected source type.
• Source Status — This value reports the status of the input connection.
• Unplugged — Indicates that either there is no source connected or no invalid video
is present.
• Active — Indicates that a valid video connection is present.

Streams panel

The bottom, Streams, panel of the video encoder Configuration page (b on figure 26)
provides details of any active video encoder streams. The data transport method, TCP or RTP,
is defined on the decoder configuration page (see “Configure Encoders or Decoders”).
Multicasting is selected on this page (see “Enable multicast streaming“ to select the
multicast and “Data Transport Methods“ for definitions of the methods).
The New Export Stream function is not supported.
VN-Matrix 325 Serial Digital Over IP CODEC • Operation 37