Extron electronic 600, 800, 300S, 300C manual Installing the Cables and AAPs, AAP Shelf Brackets

Preparing the Table with a Hole Saw (Cable Cubby 300C Only)

Prepare the table with a hole saw as follows:

1.On the tabletop or other installation surface, mark the 6 inch circle, then find and mark the center of the circle.

CAUTION: Risk of injury to the eyes. Wear safety glasses when operating the drill. Failure to comply can result in eye injury.

2.Using a portable drill with a 6-inch (or 152 mm) hole saw, carefully cut the opening in the table surface at the desired location (see figure 6). Extron is not responsible for an improperly positioned Cable Cubby.

ATTENTION: Potential damage to property. Use a portable drill with sufficient power to handle the 6-inch hole saw. Exercise caution when handling the drill and hole saw. Take care to protect the mounting surface from damage.

Figure 6. Cutting the Opening with a Hole Saw

Installing the Cables and AAPs

Each Cable Cubby model ships with one or two moveable AAP shelf assemblies.

AAP Shelf Brackets

Each shipped AAP shelf assembly consists of a set of shelf brackets and a number of cable pass-through (split) AAPs. Depending on the Cable Cubby model, each set of shelf brackets supports either two-, three-, or four-space AAPs (see figure 7).

Four-Space Shelf Bracket	Three-Space Shelf Bracket	Two-Space Shelf Bracket
and Split AAPs	and Split AAPs	and Split AAPs

Figure 7. Shelf Brackets

Cable Cubby 300/600/800 • Installation 7