Extron electronic 300S, 600, 800, 300C manual Removing the Cubby and its Shelves

Extron Cable Cubby 800

Phillips Head Screw

(Secures AAP Shelf Assembly

and Power Module.)

Pins

Screw Clamp

Figure 11. Removing the Cubby and its Shelves

4.Lift the enclosure from the table.

CAUTION: Risk of personal injury. The flanged edges of the top of the surface enclosure are sharp. Exercise caution when the cubby is not installed in a table to prevent personal injury.

ATTENTION: Potential Damage to Property. The flanged edges of the top of the cubby are bevelled to an ultra-fine thickness of less than 0.04 inch (4/100 inch; approximately 1 mm). These edges are soft and can be easily nicked or bent. Exercise caution when handling and mounting the enclosure. Mishandling can damage the appearance of the enclosure.

5.Remove the AAP shelf assembly(ies) or power module by removing the four Phillips head screws on the front and rear of the Cable Cubby and gently pushing the assembly(ies) out through the top or bottom of the cubby.

6.Perform the desired maintenance procedure.

7.Reinstall the AAP shelf assembly(ies).

8.Carefully lower the Cable Cubby into the hole in the table.

9.From the underside of the table, reinstall the screw clamps on the enclosure at a height at which the clamp will reach the underside of the tabletop.

Cable Cubby 300/600/800 • Maintenance and Modifications 13