Extron electronic 300C, 600, 800 manual Cable Cubby 300S US/domestic Enclosure, Extron Cable Cubby

Figure 1. Cable Cubby 300S US/domestic Enclosure

The AAP spaces inside the Cable Cubby allow you to customize the enclosure to meet your unique needs. The split AAPs (included) can store almost any type of cable you might encounter. The Extron line of passive AAPs allows you to customize the AAP with almost any kind of pass-through connectivity you may need.

The elevation of the AAPs inside the cubby and the arrangement of the AAPs and the power outlets are adjustable to suit cable lengths and connector types.

The installed Cable Cubby fits nearly flush within a table or podium top, storing the AAPs and cables out of the way and out of sight. To access the AAPs and connectors, lift the lid (see figure 2). Half-moon cutouts in the lid allow you to run cables in or out and then close the lid. The lid can also be lowered into its recessed position.

Extron

Cable Cubby 800

Hideaway Cable

Access Enclosure

15-pin HD Cable

Audio Cable,

Network Cable

Mounted through a table or podium

Figure 2. Typical Cable Cubby 800 Application

The Cable Cubby 300 is available with either a round or a rectangular top. The other Cable Cubby models all have rectangular tops only. Preparing the table to install a Cable Cubby 300C (round) requires drilling a hole in the table with a 6-inch hole saw (see figure 3). Preparing the table to install a square cubby requires routing a square hole in the table top. Sheet metal routing templates are available (see “Routing Template Part Numbers” on page 19 for part numbers).

Cable Cubby 300/600/800 • Introduction 2