Extron electronic FPC 5000 manual 6 - Connecting the FPC directly to a switcher BME

Models: FPC 5000

1 60
Download 60 pages 43.32 Kb
Page 14
Image 14
Figure 2-6 — Connecting the FPC directly to a switcher BME

FPC Installation and Operation, cont’d

For direct connection to BME 0 — Plug the RJ-45 connector on the opposite end of the CAT 5e or higher cable directly into the BME 0 Ethernet port (figure 2-6). Wire the CAT 5e or higher cable as a crossover cable (See Cabling and RJ-45 connector wiring in this chapter). For a multi-BME system, ensure that you connect the FPC to BME 0.

Crossover Cable

FPC 5000

PWR

HDD

T/R

RESET

MATRIX SWICHER CONTROLLER

FPC 5000

MATRIX 12800

WIDEBAND VIDEO

Matrix 12800

Figure 2-6 — Connecting the FPC directly to a switcher BME

For Ethernet connection to the Matrix 12800 system — Plug the RJ-45 connector on the opposite end of the CAT 5e or higher cable into the Ethernet LAN on which BME 0 of the Matrix 12800 system resides (figure 2-7). Wire the CAT 5e or higher cable as a patch (straight) cable (See Cabling and RJ-45 connector wiring in this chapter).

Patch Cable

Patch Cable

FPC 5000

PWR

HDD

T/R

RESET

MATRIX SWICHER CONTROLLER

FPC 5000

Ethernet

MATRIX 12800

WIDEBAND VIDEO

Matrix 12800

Laptop

Figure 2-7 — Connecting the FPC through a LAN

2AC power input connector — Connect a standard IEC power cord between the rear panel AC power input connector and a 100 to 240VAC, 50 Hz or 60 Hz power source.

2-6 FPC 5000 Front Panel Controller FPC Installation and Operation

Page 14
Image 14
Extron electronic FPC 5000 manual 6 - Connecting the FPC directly to a switcher BME, 7 - Connecting the FPC through a LAN