Extron electronic FPC 5000 manual Upgrading the Software, Matrix 12800 Operation

FPC Installation and Operation, cont’d

Upgrading the Software

The Front Panel Controller software is factory installed on the FPC computer’s hard drive and it is also included on a CD-ROM. Extron sends any needed software upgrades on a CD-ROM.

Upgrade the FPC software as follows:

1.	If necessary, log the FPC 5000 on to the Matrix 12800 system as an
	administrator. See Starting Up the Controller and Logging In and Out in
	chapter 3, Matrix 12800 Operation.
2.	On the front panel LCD, touch the blue Admin button.
3.	On the front panel LCD, touch the purple Misc button.
4.	On the front panel LCD, touch the gray Re-Install FPC Software button. The
	FPC prompts you to insert the CD-ROM containing the FPC software into the
	CD tray. To exit without installing the software, touch on the gray Cancel
	button.
5.	On the rear of the FPC, press the eject button on the CD-ROM drive
	(figure 2-11). The drive’s LED flashes and the CD tray partially ejects.

On the rear of the FPC, gently pull the CD tray to its fully extended position.

CD Eject Button

EXT.FDD K/B MOUSE NET

C

PRN

DIO

Figure 2-11 — Eject button location

2-10 FPC 5000 Front Panel Controller • FPC Installation and Operation