Projector mounting, PMK 300 mounting | Extron electronic HDMI 201 Tx/Rx

Installation and Operation, cont’d

1.	Loosely attach the mounting brackets to the transmitter
	or receiver using the four machine screws and washers
	supplied with the mounting kit.
2.	Hold the transmitter or receiver against the inside of the
	surface through which it will be mounted. Mark the four
	screw holes on the inside of the surface to which you are
	mounting the device.
3.	Drill four pilot holes, each 3/32" in diameter by 1/4" deep,
	where you made marks.
4.	Using the provided four wood screws, secure the brackets
	to the mounting surface.
5.	Slide the transmitter or receiver up and down in the
	mounting brackets until the face of the transmitter or
	receiver is at the desired height. Tighten the screws that
	secure the brackets in place.

If the screws are inaccessible to a screwdriver:

a. Mark the location of the brackets relative to the screws.

b. Remove the transmitter or receiver from inside the furniture.

c. Tighten the screws.

d. Replace the unit inside the surface (step 4).

Projector mounting

The receiver can be mounted on a projector bracket using either of the following optional Extron projector mounting kits:

•PMK 300 projector mounting kit (part #70-374-01)

•PMK 350 low profile projector mounting kit

(part #70-563-02[black] or part #70-563-03[white])

Mount the receiver to a PMK 300 bracket as follows:

1.	If necessary, remove the feet from the bottom of the
	receiver.
2.	Mount the receiver to one of the bracket’s three mounting
	plates using two of the supplied 4-40 x 3/16" screws in
	opposite (diagonal) corners to secure the device to the
	bracket. It can be vertically mounted facing either up or
	down (figure 2-5).

NOn the side mounting plates, the device is typically mounted on the outside of the bracket.

On the front mounting plate, the device is typically mounted on the inside of the bracket.

Side Mounting

Plate

Bracket

Brace

U-Bolt

Extron

DVI 201 or HDMI 201

Receiver

Power Supply

Extron

PMK 300

Multi-product Projector Mount Kit

Front Mounting

Plate

3. If the power supply is connected to the receiver, use the two included tie wraps to strap the power supply to one of the brackets.

2-6

HDMI 201 Tx/Rx • Installation and Operation

2-7