Extron electronic HDMI 201 Tx/Rx Connections, Transmitter connections, Final installation

Installation and Operation, cont’d

Final installation

After testing and making any adjustments, do the following: 1. At the power outlet, unplug the power supply.

NOne power supply can power both the transmitter and the receiver, so only one unit needs a power supply.

2. Mount the transmitter or receiver into the wall box, and attach the supplied Decora faceplate to the unit, as shown in figure 2-11.

Connections

Transmitter connections

The rack-mountable transmitter is in a quarter rack width enclosure. The wall-mountable transmitter is in an enclosure that can be mounted in UL standard wall boxes with Decora®- style face plates.

Figure 2-12 shows the front panel of the HDMI 201 A D Tx. Figure 2-13 shows the rear panel of both HDMI 201 Tx models.

HDMI 201 A D Tx Front Panel

Wall Box

Wall opening is flush with edge of box.

		TPU	T
OU				MI
AUDIO	-R		HD
AUDIO	-L
-232
RS THRU
PASS

Extron HDMI 201 A D

Decora Faceplate

INPUT

HDMI

1

AUDIO-R

Figure 2-11 — Mounting the transmitter or receiver

3. At the power outlet, reconnect the power supply. This powers up both units.

	RS-232		3
	PASS THRU	AUDIO-L
2	Rx
	Tx

	Figure 2-12 — HDMI 201 Tx front panel connectors
A	HDMI Input connector — Connect an HDMI cable between
	this port and the HDMI output port of the digital video source.
	See "HDMI connector pin assignments," on page 2-22, for pin
	assignments.
B	RS-232 connector — Connect a serial communications port to
	this 3.5 mm, 3-pole captive screw connector for bidirectional
	RS-232 communication. See "RS-232 connector wiring," on
	page 2-26, to wire the connector.

2-14 HDMI 201 Tx/Rx • Installation and Operation HDMI 201 Tx/Rx • Installation and Operation 2-15