Installation and Operation, cont’d
1U Universal Rack Shelf | 1/2 Rack Width |
| Front False |
| Faceplate 1/4 Rack Width |
| Front False |
| Faceplate |
Both front false faceplates use 2 screws.
Use 2 mounting holes on opposite corners.
(2)
Figure 2-3 — Under-desk mounting
Figure
Under-furniture mounting
The unit can be mounted under a horizontal surface using an optional MBU 125
1. | Secure the |
| transmitter or receiver with the four machine screws |
| provided in the mounting kit (figure |
2. | Hold the transmitter or receiver with attached brackets |
| against the underside of the desk or other furniture. Mark |
| the location of holes for screws on the desk. |
3. | Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot |
| holes in the table or desk at the marked screw locations |
| from the underside or inside (the concealed side) of the |
| furniture, where the transmitter or receiver will be located. |
4. | Insert the four wood screws into the pilot holes. Fasten |
| each screw into the installation surface until just less than |
| 1/4" of the screw head protrudes. |
5. | Align the installed screws with the slots in the mounting |
| brackets, and place the transmitter or receiver against the |
| surface, with the screws through the bracket slots. |
6. | Slide the transmitter or receiver slightly forward or back, |
| then tighten all four screws to fasten it in place. |
Through-furniture mounting
The transmitter or receiver can be mounted through a desk or other furniture using an optional Extron MBD 129
Figure 2-4 — Through-desk mounting
HDMI 201 Tx/Rx • Installation and Operation | HDMI 201 Tx/Rx • Installation and Operation |