Installation and Operation
Mounting the Tx/Rx
CInstallation and service must be performed by authorized personnel only.
Non-Decora unit mounting
The 1" high, quarter rack width HDMI 201
Tabletop placement
Affix the four included rubber feet to the bottom of the unit and place it in any convenient location.
Rack mounting
UL requirements
The following Underwriters Laboratories (UL) requirements pertain to the installation of the transmitter or receiver into or onto a rack (figure
1. Elevated operating ambient — If the equipment is installed in a closed or
2. Reduced air flow — Installation of the equipment in a rack should be such that the amount of air flow required for safe operation of the equipment is not compromised.
3. Mechanical loading — Mounting of the equipment in the rack should be such that a hazardous condition is not achieved due to uneven mechanical loading.
4. Circuit overloading — Consideration should be given to the connection of the equipment to the supply circuit and the effect that overloading of the circuits might have on overcurrent protection and supply wiring. Appropriate consideration of equipment nameplate ratings should be used when addressing this concern.
5. Reliable earthing (grounding) — Reliable earthing of
VersaTools Rack Shelf
1/4 Rack Width Front
False Faceplate
Use 2 mounting holes on
opposite corners.
(2)
Figure
Rack mounting instructions
For optional rack mounting, mount the transmitter or receiver on any of the following rack shelves:
•RSF 123 3.5" deep 1U VersaTools® rack shelf kit (part
•RSB 123 3.5" deep 1U VersaTools rack shelf (part
•RSU 126 6" deep 1U universal rack shelf kit (part
•RSB 126 6" deep 1U basic rack shelf (part
•RSU 129 9.5" deep 1U universal rack shelf kit (part
•RSB 129 9.5" deep 1U basic rack shelf (part
On the
1. | Remove the feet from the bottom of the transmitter or |
| receiver unit, if they are installed. |
2. | Mount the transmitter or receiver unit using two |
| |
| secure the transmitter or receiver to the shelf. |
3. | Install false faceplate(s) or other unit(s) to the rack shelf. |
HDMI 201 Tx/Rx • Installation and Operation | HDMI 201 Tx/Rx • Installation and Operation |