Extron electronic MMX 32 VGA A user manual Connecting an MMX 32 AAP or MMX 32 Maap control panel

Remote Control, cont’d

Connecting an MMX 32 AAP or MMX 32 MAAP control panel

Each Extron MMX 32 AAP and MMX 32 MAAP contact closure remote control panel can control one output on the switcher. To connect a panel to the switcher, wire the captive screw connectors on the rear of the panel as follows.

43

2 5

1

Figure 3-8 — MMX 32 AAP rear panel

34

2 5

1

Figure 3-9 — MMX 32 MAAP rear panel

Input Selection connector

1Input 1 pole — Connect this pole of the captive screw connector to pin 1 (if the panel will control output 1) or pin 7 (if the panel will control output 2) of the MMX 32 VGA A’s Remote connector.

2Input 2 pole — Connect this pole of the captive screw connector to pin 4 (output 1) or pin 8 (output 2) of the MMX 32 VGA A’s Remote connector.

3Input 3 pole — Connect this pole of the captive screw connector to pin 6 (output 1) or pin 9 (output 2) of the MMX 32 VGA A’s Remote connector.

Tally Power connector

45 VDC pole — Connect this pole of the captive screw connector to the 5 VDC pole of the Tally Pwr connector on the

MMX 32 VGA A.

5GND pole — Connect this pole of the captive screw connector to the ground pole of the Tally Pwr connector on the

MMX 32 VGA A.

Control

Document

Camera	Extron
	MMX 32 VGA A
	Matrix Switcher

Audio System

	Podium	LCD Monitor
Extron	Computer
		with Audio	Projector
AAP 102 with
MMX AAP		Laptop

Figure 3-10 — Typical MMX 32 VGA A application using contact closure remote control

Only one MMX 32 AAP or MMX 32 MAAP control panel can be used to control each output.

Extron recommends shielded twisted pair cable, such as STP 22 dual plenum cable, part #22-162-03(or equivalent). Unshielded cable can allow crosstalk and interference between the MMX and the control panel.

3-14 MMX 32 VGA A • Remote Control MMX 32 VGA A • Remote Control 3-15