CThe length of exposed wires is critical. Ideal length is 3/16” (5 mm). If the stripped section of wire is longer than 3/16” the exposed wires may touch, causing a short circuit. If the stripped section of wire is shorter, wires can easily be pulled out even if tightly fastened by the captive screws.
NDo not tin the stripped leads! Tinned wires are not as secure in the captive screw and direct insertion connectors and could be pulled out.
Verify the polarity before connection! Plug in the power supply in with no load and check the output with a voltmeter.
WThe two power cord wires must be kept separate while the power supply is plugged in. Remove power before wiring.
Use the supplied
NThe transmitter/receiver pair may have shipped with a blue captive screw connector. This connector does not include the extended tail or tie‑wrap but can be plugged into either a blue or an orange power receptacle.
Transmitter/receiver combinations containing new generation,
Single Power Supply (remote powering)
Transmitter | Receiver |
Old Generation | Old Generation |
Old Generation | New Generation, Jumpered* |
New Generation, Jumpered* | Old Generation |
New Generation, Jumpered* | New Generation, Jumpered* |
*Configured for stereo audio |
|
NWhen configured for stereo audio, a single power supply connected to either the transmitter or receiver can power both units if there is less than 500 feet (150 meters) of STP/UTP/FTP cable between the two. If the transmitter and receiver are separated by greater than 500 feet, connect a power supply to both units regardless of the model and jumper configuration.
G Power LED — Indicates power is applied to the MTP. |
|
VersaTools ® MTP Series • Installation |
Refer also to the VersaTools ® MTP Series User’s Manual at www.extron.com.
