Extron electronic MTP SW6 Switch mode, Delay Adjust skew adjustment control This control

Installation and Operation, cont’d

H	Delay Adjust (skew adjustment) control — This control
	delays the selected red, green, or blue video signal by up
	to 62 nanoseconds. The delay is applied in incremental,
	2-nanosecond, steps. Rotate the control counterclockwise to
	reduce the delay or clockwise to increase the delay.
	The control’s movement is smooth; it does not have mechanical
	steps or high- and low-limit stops.
	Watch the displayed image to observe the steps of delay.
	The Delay Red, Green, or Blue LED (G) (whichever is selected)
	flashes to indicate that the control has reached the minimum
	(counterclockwise rotation) or maximum (clockwise rotation)
	limit.
I	Level control — The Level control alters the video output
	voltage to affect the brightness of the displayed image. Adjust
	the knob while viewing the displayed image to set the level/
	boost that provides the best picture quality.
J	Peaking control — Peaking affects the sharpness of a picture.
	Increased peaking can compensate for mid- and high-frequency
	detail loss from low bandwidth system components or
	capacitance in long cables. The minimum setting (at the
	counterclockwise limit) provides no peaking. The maximum
	setting (at the clockwise limit) provides 100% peaking. Adjust
	this control while viewing the displayed image to obtain the
	optimum picture sharpness.

Switch mode

In auto switch mode, the switcher automatically switches to the highest-numbered input with video sync signals present. Input selection, by the front panel buttons or the Remote port, is blocked while in auto switch mode. However, the front panel LEDs remain functional and the Input 1 through Input 3 buttons can be used to view or change the mode.

NThe switcher must be in normal (manual) mode for contact closure to work.

NAudio breakaway (available via SIS or Windows-based control program control only) is disabled in auto switch mode; audio always follows video.

Turn auto switch mode on as follows:

1. Press and hold the Mode (Input 1) button.

2. Press and release the Auto (Input 3) button. The Auto Switch Active LED lights.

3. Release the Mode button.

NManual switching is disabled.

Turn auto switch mode off as follows:

1. Press and hold the Mode (Input 1) button.

2. Press and release the Normal (Input 2) button. The Auto Switch Active LED goes off.

3. Release the Mode button.

NWhen the switcher exits auto switch mode, it deselects all inputs (no output).

2-14 MTP SW6 • Installation and Operation MTP SW6 • Installation and Operation 2-15