Reference Information
Specifications
Video
Gain | Unity |
Video input — see MTP Series transmitter specifications
Number/signal type | 6 sets of proprietary analog signals |
Connectors | 6 female |
Video output — See MTP Series receiver specifications
Number/signal type | 1 set of proprietary analog signals |
Connectors | 1 female |
Maximum resolution | 1920x1200 |
NRefer to the user's manual for the maximum distances recommended for specific resolutions.
Audio
Number/signal type | 1 set of proprietary analog signals |
Connectors | 1 female |
Gain | Unbalanced output: 0 dB; |
| balanced output: +6 dB |
Frequency response | 20 Hz to 20 kHz, ±1 dB |
THD + Noise | 0.15% @ 1 kHz, |
| 0.3% @ 20 kHz at nominal level |
S/N | >70 dB at maximum output (unweighted) |
CMRR | >43 dB @ 20 Hz to 20 kHz |
Audio input — see MTP Series transmitter specifications
Number/signal type | 6 sets of proprietary analog signals |
Connectors | 6 female |
N0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu
Audio output — local
Number/signal type | 1 dual mono, balanced/unbalanced |
Connectors | (1) 3.5 mm captive screw connector, 5 pole |
Impedance | 50 ohms unbalanced, 100 ohms balanced |
Gain error | ±1 dB channel to channel |
Maximum level | >+18 dBu, balanced or unbalanced at |
| 1% THD+N |
Maximum level (600 ohm) | >+15 dBm, balanced or unbalanced at |
| 1% THD+N |
Audio output — see MTP Series receiver specifications
Number/signal type | 1 set of proprietary analog signals |
Connectors | 1 female |
Control/remote— switcher host control
Serial control port | 1 |
Baud rate and protocol | 9600 baud, 8 data bits, 1 stop bit, no parity |
Serial control pin configuration .. | 2 = TX, 3 = RX, 5 = GND |
Program control | Extron's control/configuration program |
| for Windows® |
| Extron's Simple Instruction Set (SIS™) |
Control/remote — external device (pass-through)
Serial control port | |
| 5 pole (uses 3 poles) |
Baud rate and protocol | Up to 38400 baud, |
| 1 or 2 stop bits; odd, even, or no parity; |
| XON, XOFF, or no flow control |
NProtocol is mirrored between the switcher and the receiver.
Serial control pin configuration .. 1 = TX, 2 = RX, 3 = GND
General
Recommended cable type | CAT5/5E/6 (shielded or unshielded) |
External power supply | 100 VAC to 240 VAC, 50/60 Hz, external; |
| to 12 VDC, 2 A, regulated |
Power input requirements | 12 VDC, 0.8 A |
Temperature/humidity | Storage: |
| 10% to 90%, noncondensing |
| Operating: +32 to +122 °F (0 to +50 °C) / |
| 10% to 90%, noncondensing |
Cooling | Convection, vents on both sides |
MTP SW6 • Reference Information |
