Controls and Installation
Front and Rear Panels
Front faceplate
1 |
|
|
|
| AUTO POWER |
2 |
|
|
| 100% | 5 |
6 | UNITY | |
50% |
| |
|
|
GAIN/PEAKING
3 4
Figure 2-1 — P/2 DA2 WM faceplate features
Both WM and EC models have the same front and rear panel connectors and features. See figure
1
2Audio input jack — 3.5 mm stereo input
3VGA input connector — HD
4Buffered local monitor output — HD
5ID bit termination DIP switches — provides proper ID bit termination for a laptop computer that is not attached to a local monitor.
6
100% – increases the output signal level and adds
100% of the maximum peaking to the signal
Unity – output signal level is same as that of input with no added peaking
50% – increases the output signal level and adds
50% of the maximum peaking to the signal
If the edges of the image seem to exceed their
boundaries, or if thin lines and sharp edges look thick and fuzzy, try changing the level/peak setting.
1 |
| P/2 DA2 EC | |
| AUTO POWER |
| |
2 |
|
| |
GAIN/ | ID PINS | ||
PEAKING | |||
| |||
UNITY 100% | 50% |
| |
6 |
| 5 | |
| 3 | 4 |
Figure 2-2 — P/2 DA2 EC faceplate features
Rear connectors
1 2
NC |
|
|
L | R |
NC |
|
|
L | R |
3
Figure 2-3 — P/2 DA2 WM rear connectors
1Power input — 12 - 24 VAC or DC (captive screw connector). The center pole contains no conductor. Connect the conductors to the outer two poles only.
Positive
N/C
Negative
2Audio output — 3.5 mm captive screw stereo output
3VGA output — HD
P/2 DA2 WM/EC Controls and Installation | P/2 DA2 WM/EC Controls and Installation |