Controls and Installation, cont’d
Figure 2-6 — Fastening captive screws
3.Slide the audio cable connector into the audio output connector on the interface.
Balanced audio
To attach the interface to a balanced audio system, do the following:
1.Attach the audio cable to a balanced speaker input connector (tip, ring, and sleeve).
3.Slide the audio cable connector into the audio output connector on the interface.
Installing Architectural Adapter Plates
The P/2 DA2 WM AAP may have up to 4 optional adapter plates and the P/2 DA2 EC AAP can have up to 3 adapter plates. The adapter plates provide a convenient method of adding various connectors for specific audio and video requirements. The adapter plates must be ordered separately and must be attached to the faceplate and cabled before attaching the WM AAP model to the wallmount bracket or the EC AAP model to the Euro Channel. See figure
1.Insert the adapter plate captive screws through the front faceplate holes. Secure the adapter plate using the supplied washers and nuts.
Tip (+) | Sleeve |
Ring
Tip (+)
Sleeve
AUTO | POWER |
| |
AUDIO | |
100% |
| |
UNITY | INPUT | |
50% | ||
| ||
GAIN/PEAKING | BUFFERED |
LOCAL | ID | PIN 4 | |
ID | |||
MONITOR | PIN | 11 | |
Adapter Plate
|
| |
|
| Washer |
|
| P/2 DA2 WM |
|
| (up to 4 Plates) |
P/2 | DA2 | WM |
| ||
|
|
2.Attach the audio cable to the audio cable connector (Extron part number
Balanced Output
Tip
Ring
Sleeve (s)
Tip
Ring
Connect the sleeve(s) to ground (GND). Connecting the sleeve(s) to a negative
| P/2 DA2 EC AAP |
|
| AUTO POWER |
|
GAIN/ | ID PINS | P/2 DA2 EC |
PEAKING | ||
UNITY 100% 50% |
| (up to 3 Plates) |
|
|
Figure 2-7 — Installing adapter plates
2.Attach the output cables to the back side of the adapter plate. Some adapter plates may require that conductors be soldered to the connectors. Attach foil and braided shields to ground connections.
P/2 DA2 WM/EC Controls and Installation | P/2 DA2 WM/EC Controls and Installation |
